Flight Planning

Flight Sim Fuel Calculators: How to Plan Fuel Loads

How flight sim fuel calculators work, the parts of a fuel plan, reserve rules to copy, a worked light-aircraft example, and how to load fuel in MSFS and X-Plane.

On this page
  1. What a flight sim fuel calculator does
  2. The parts of a fuel plan
  3. Reserve rules worth copying in the sim
  4. Fuel calculator options
  5. Calculating fuel by hand for a light aircraft
  6. Pounds, kilograms, gallons and liters
  7. Loading the fuel in your simulator
  8. Weight limits and why more fuel isn’t always safer
  9. Common fuel planning mistakes

What a flight sim fuel calculator does

A fuel calculator works out how much fuel to load for a flight. At its simplest, it multiplies the aircraft’s fuel burn by the flight time. Better calculators add the extra fuel real pilots carry for taxi, delays, diversions and reserves, and account for aircraft weight, winds and altitude.

In a simulator, getting fuel right matters for two reasons. Too little and you run dry before the destination, especially if you divert or hold. Too much and the aircraft is heavier than it needs to be, which affects takeoff performance and climb, and in an airliner can push you over landing weight limits.

The parts of a fuel plan

Airline-style planning splits fuel into parts. Planners like SimBrief show each one on the briefing, and knowing what they mean helps you check the numbers.

Component What it covers
Taxi fuel Engine start and taxi to the runway
Trip fuel Takeoff, climb, cruise, descent and approach to the destination
Contingency A margin for things like unexpected winds or routing changes, often a percentage of trip fuel
Alternate fuel Flying from the destination to the alternate airport
Final reserve A fixed amount that should still be in the tanks on landing
Extra fuel Anything the captain or dispatcher adds, for weather or expected holding
Block fuel The total loaded before engine start

For a light aircraft flight, you can simplify this to taxi fuel, trip fuel and a reserve.

Reserve rules worth copying in the sim

Nothing forces you to carry reserves in a simulator, but following real-world minimums makes flights more realistic and gives you a buffer for mistakes. Some commonly cited US rules for general aviation:

  • VFR by day: enough fuel to reach the first point of intended landing and then fly for at least 30 minutes at normal cruise.
  • VFR at night: the same, but at least 45 minutes.
  • IFR: enough to reach the destination, then the alternate if one is required, then fly for 45 minutes at normal cruise.

Airlines and other countries use their own fuel policies, which typically include contingency fuel, alternate fuel and a final reserve based on holding for around 30 minutes. Many instructors treat legal minimums as a floor rather than a target, so adding a comfortable margin is sensible in the sim too.

Fuel calculator options

  • SimBrief. The most popular choice for airliners. It calculates block fuel from aircraft profiles, the route, cruise level, winds and your chosen alternate and contingency policy, and lists each component on the briefing. Many add-on aircraft and the MSFS 2024 EFB can import the fuel figures along with the route.
  • Aircraft EFBs and tablets. Many detailed airliner add-ons include their own tablet or loadsheet tools for setting fuel, payload and weights, often with SimBrief integration.
  • Little Navmap. It can estimate fuel for a route using an aircraft performance file you create, which suits light aircraft and turboprops.
  • Spreadsheets and online calculators. Community-made spreadsheets for specific aircraft have been around for many years, some built from real planning tables. Simple online fuel calculators also exist. They vary in accuracy, so cross-check against the aircraft’s documentation.
  • Pen and paper. For a light aircraft, the manual method below is quick and teaches you what the tools are doing.

Our flight planning software overview compares these tools more broadly.

Calculating fuel by hand for a light aircraft

You need three numbers: the flight time, the fuel burn per hour at your planned power setting, and your reserve policy. Burn figures come from the aircraft’s operating handbook or the sim aircraft’s documentation. The numbers below are illustrative, not data for a specific aircraft.

Example: a 120 nautical mile VFR flight in a four-seat piston single.

  1. Groundspeed and time. Planned true airspeed is 110 knots, with a 10-knot headwind, so groundspeed is about 100 knots. 120 NM ÷ 100 kt = 1.2 hours, or 72 minutes.
  2. Add climb. Climb burns more fuel than cruise. A simple approach is to add a few minutes of extra fuel for the climb, say 5 minutes.
  3. Trip fuel. At 9 gallons per hour, 77 minutes is about 11.6 gallons.
  4. Taxi fuel. Allow about 1 gallon.
  5. Reserve. 45 minutes at 9 gallons per hour is 6.75 gallons. (The legal VFR day minimum would be 30 minutes, but extra margin is a good habit.)
  6. Total. 11.6 + 1 + 6.75 ≈ 19.4 gallons. Round up to about 20 gallons, and make sure that’s usable fuel, not total tank capacity.

To work out the flight time in the first place, see our guide to planning a VFR cross-country flight in a simulator, which covers groundspeed and wind correction.

Pounds, kilograms, gallons and liters

Sims and aircraft mix units, which causes many fuel mistakes:

  • Light piston aircraft usually measure fuel in US gallons or liters.
  • Airliners usually measure fuel by weight, in pounds or kilograms, and different add-ons use different units.
  • 1 kilogram is about 2.2 pounds, and 1 US gallon is about 3.79 liters.
  • Avgas weighs roughly 6 pounds per US gallon, and jet fuel roughly 6.7 pounds per US gallon. Exact values vary with temperature.

Before entering a figure, check which unit the sim screen or add-on tablet expects. Entering a kilogram figure into a pounds field leaves you with less than half the fuel you planned.

Loading the fuel in your simulator

  • MSFS 2024: set fuel and payload in the EFB or the aircraft’s own tablet; a SimBrief import can fill in the planned figures.
  • MSFS 2020: use the fuel and payload settings from the world map or in the cockpit, or the aircraft’s own EFB if it has one.
  • X-Plane: use the weight, balance and fuel screen in the flight configuration, or the aircraft’s own loading tool for third-party airliners.

Detailed add-on aircraft often override the sim’s default fuel screen. If the fuel gauges don’t show what you set, check the aircraft manual for its preferred loading method.

Weight limits and why more fuel isn’t always safer

Filling every tank seems safe, but fuel is heavy. In a light aircraft, full fuel can mean you can’t also carry full seats and baggage without exceeding maximum takeoff weight. In an airliner, extra fuel raises takeoff weight and fuel burn, and on short flights can leave you above maximum landing weight at the destination. Planners such as SimBrief check these limits for you; when calculating by hand, compare your total weight against the aircraft’s published limits.

Common fuel planning mistakes

  • Planning with total tank capacity instead of usable fuel.
  • Ignoring headwinds, which lengthen the flight and increase trip fuel.
  • Forgetting taxi fuel, or fuel for the climb.
  • Mixing up pounds, kilograms, gallons and liters.
  • Using a burn rate for a different power setting or altitude than you’ll actually fly.
  • Skipping alternate fuel on IFR flights to destinations with poor weather.
  • Running the sim at increased simulation speed without checking fuel more often.

The complete guide to flight planning

Flight Planning Software for Flight Simulators
Read the guide

Keep exploring

Guides from other topics

All topics →