Stalls are among the most important maneuvers in pilot training. You don’t practise them to get good at stalling. You practise them to recognise a stall coming and recover instinctively if it ever happens unintentionally. A flight simulator is a useful place to learn the procedures and build the reflexes before and alongside training with an instructor. This guide covers the two stalls in the US private pilot standards, power-off and power-on, plus the recovery technique that applies to both.
One important caveat: a simulator is a supplement, not a substitute. Real stall training should always be done with a qualified flight instructor in a suitable aircraft.
What a Stall Really Is
A stall happens when the wing exceeds its critical angle of attack, the angle between the wing and the oncoming air beyond which smooth airflow separates from the upper surface and lift drops sharply. That can happen at any airspeed, in any attitude, at any power setting. Airspeed is only an indirect clue. What matters is angle of attack, which is why the first step in every recovery is to reduce it. For the aerodynamics, see principles of flight and aircraft flight controls.
Why Practise Stalls in a Simulator?
- You can rehearse the recovery sequence until it’s automatic, with no cost and no risk.
- You can repeat entries quickly using a saved flight at a safe altitude.
- You learn to recognise the cues the sim provides: stall warning horn, high nose attitude, decaying airspeed, and mushy controls.
- You’ll arrive at real stall lessons knowing the procedure, so you can focus on what the airplane actually feels like.
What the Simulator Can and Can’t Show You
Be clear-eyed about the limits:
- No physical sensations. You won’t feel the buffet, the sinking feeling, or the G-load changes.
- Flight models vary. Stall behaviour, wing drop, and spin characteristics differ between simulators and between individual aircraft models, and they may not match the real airplane closely.
- Control feel is different. Spring-loaded sim controls don’t go light and mushy the way real controls do near a stall.
So use the sim to learn the procedure and decision-making. Don’t use it to learn exactly how a particular real airplane will behave.
Setting Up for Stall Practice
- Aircraft: a simple trainer such as a Cessna 172.
- Assists off: turn off any AI anti-stall protection, auto-rudder, and assisted controls.
- Altitude: start several thousand feet above the ground. Real-world standards require recovery to be completed no lower than 1,500 feet AGL, and keeping that margin in the sim is a good habit.
- Weather: clear skies and calm wind.
- Saved flight: save a situation in level cruise, trimmed, so you can restart instantly.
- Rudder: pedals or a twist-grip stick, because coordination matters a lot near the stall.
- Warm up: fly a few minutes of slow flight first to get a feel for the airplane at low speed.
The Stall Recovery Sequence
FAA guidance describes a recovery sequence along these lines:
- Disconnect the autopilot, if it’s engaged.
- Reduce the angle of attack: lower the nose until the stall warning stops. This is the critical step.
- Level the wings with coordinated aileron and rudder.
- Add power as needed.
- Retract speed brakes or spoilers, if applicable.
- Return to the desired flight path, smoothly, without causing a secondary stall.
The order matters. Adding power or rolling the wings level before reducing angle of attack can make things worse.
Power-Off Stall (Approach-to-Landing)
The power-off stall simulates letting airspeed decay on approach, for example while distracted turning onto final.
Entry
- Make clearing turns and note your heading and altitude.
- Carburettor heat on if applicable, reduce power, and slow to approach speed.
- Extend flaps to the landing configuration, in stages within the white arc.
- Establish a stabilised descent, as if on final.
- Reduce power to idle and smoothly raise the nose to an attitude that will induce a stall. Keep the wings level, or hold a shallow bank if practising a turning stall.
- Keep the ball centered with rudder.
- Recover at the first indication of a stall, or at the full stall, depending on what you’re practising.
Recovery: follow the sequence above. Lower the nose, wings level, full power (carburettor heat off), then retract flaps in stages as you establish a climb.
Power-On Stall (Takeoff and Departure)
The power-on stall simulates pitching up too steeply after takeoff or during a climb. That’s especially dangerous because it happens close to the ground.
Entry
- Make clearing turns.
- Slow to around lift-off speed, configured for takeoff or departure per your aircraft.
- Set climb power, or at least the power level the standards call for.
- Raise the nose smoothly to an attitude that will induce a stall.
- Add right rudder as needed. At high power and low airspeed, left-turning tendencies such as P-factor and torque are strong.
- Recover at the first indication or at the full stall, as you’re practising.
Recovery: lower the nose to reduce angle of attack, wings level with coordinated controls, keep power at maximum, and climb out at a safe speed.
Other Stalls Worth Knowing
- Accelerated stall: a stall at higher-than-normal airspeed caused by load factor, for example pulling hard in a steep turn. Stall speed increases with load factor; in a level 60-degree bank turn the load factor is 2G, and stall speed rises by roughly 40%.
- Cross-controlled stall: a stall in an uncoordinated, skidding turn, classically when overshooting the turn to final and adding inside rudder. It can cause a sudden roll. Fly the base-to-final turn coordinated; see flying a traffic pattern in a flight simulator.
- Elevator trim stall: a strong pitch-up when full power is added with nose-up trim set, as in a go-around. Hold forward pressure and re-trim; see how to use elevator trim.
- Secondary stall: stalling again by pulling up too soon after a recovery. Let speed build before raising the nose.
Grading Yourself
For each attempt, note:
- Did you recognise the approaching stall promptly?
- Was your first action to reduce angle of attack?
- Did you stay coordinated, with the ball centered?
- How much altitude did you lose? Less is better, but never at the expense of a secondary stall.
- Did you keep your heading within about 10 degrees, or the specified bank angle in a turning stall?
- Was the transition back to climb smooth?
Common Mistakes
- Pulling back or adding power first instead of lowering the nose.
- Using aileron to pick up a dropping wing while still stalled. Reduce angle of attack first, then level the wings with coordinated controls.
- Forgetting right rudder in power-on stalls.
- Retracting all flaps at once during a power-off recovery, causing a sink.
- Pulling up too quickly after recovery and causing a secondary stall.
- Flying with assists on, which can hide or prevent the stall altogether.
For where stalls fit in a wider plan of practice, see our learning to fly with a flight simulator roadmap.